Comtech-ef-data SDM-2020 Manuale Utente Pagina 10
- Pagina / 266
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
SDM-2020 Satellite Modulator Revision 7
Preface MN/SDM2020M.IOM
viii
Trademarks
Product names mentioned in this manual may be trademarks or registered trademarks of
their respective companies and are hereby acknowledged.
Reporting Comments or Suggestions Concerning this Manual
Comments and suggestions regarding the content and design of this manual will be
appreciated. To submit comments, please contact the Comtech EF Data Technical
Publications Department: [email protected]
Overview of Changes to Previous Edition
Changes made to Rev. 6 are as follows:
Revised manual format to comply with the current Comtech EF Data standards.
Chapter 5: Front Panel Operation – Revisied the chapter to include version 9.1.2. Revised
Table 5-2 to include version 9.1.2, FW/5613-1AG.
Chapter 14: FAST – Updated procedures to comply with customer support requirements.
Appendix A – Updated remote control operation to include FW.5613-1AG and FW/5613-
2AG.
- Satellite Modulato 1
- Installation and O 1
- SDM-2020 3
- Customer Support 4
- Table of Contents 5
- Figures 7
- Trademarks 10
- Electrical Safety 11
- Environmental 11
- Installation 11
- Preface MN/SDM2020M.IOM 12
- European EMC Directive 14
- Warranty Policy 15
- Limitations of Warranty 15
- Exclusive Remedies 15
- Disclaimer 15
- Chapter 1. INTRODUCTION 17
- SSEMBLIES 20
- MODULATOR 20
- 1.2.2 DATA INTERFACES 21
- Chapter 2. SPECIFICATIONS 23
- ODULATOR SPECIFICATIONS 26
- 2.2 DIMENSIONAL ENVELOPE 28
- Figure 2-2 29
- Chapter 3. INSTALLATION 31
- NPACKING 31
- NSTALLATION 32
- 3.2.1 CABLING 34
- 3.2.2 DATA INTERFACES 35
- ATA INTERFACE REMOVAL 36
- ATA INTERFACE INSTALLATION 36
- XTERNAL CONNECTIONS 37
- 4.1.2 FAULT CONNECTOR (J2) 39
- 4.1.4 AC POWER 39
- 4.1.5 FUSE DATA 40
- OWER (OPTIONAL) 41
- ROUND (GND) OR EARTH 41
- Chapter 5. FRONT PANEL 43
- OPERATIONS 43
- NDICATORS 44
- RONT PANEL KEYPAD 45
- 5.4 MENU SYSTEM 46
- ENU TREE 48
- 5.6 OPENING SCREEN 49
- CARRIER MODE 54
- NORMAL-MODULATED 54
- 5.6.3 CONFIGURATION:SAVE 59
- 5.6.4 CONFIGURATION:RECALL 59
- TX INTERFACE 60
- COMMON 60
- MODULATOR 61
- ------- 61
- Press <ENTER> 62
- INTERFACE TYPE 69
- XXXXXXXXXXX 69
- IMPORTANT 90
- NITIAL DEFAULT SETTINGS 91
- EVISION EMULATION OPERATION 92
- Chapter 6. DATA INTERFACES 95
- 1187 116 97
- INTERFACE 100
- 7.1.1 APPLICABLE DOCUMENTS 100
- 7.1.2 DESCRIPTION 100
- 7.1.3 CONFIGURATION 102
- 7.1.4 USER INTERFACES 103
- INTERFACE) 103
- J3 PARALLELJ4 SERIALJ5 AU 104
- 7.1.4.3 AUXILIARY, J5 106
- Refer to Appendix A 107
- Chapter 8. LOW VOLTAGE 108
- DIFFERENTIAL SIGNAL (LVDS) 108
- 8.1.1 APPLICABLE DOCUMENTS 108
- 8.1.2 DESCRIPTION 108
- 8.1.3 CONFIGURATION 110
- INTERFACE FRONT PANEL MENUS 114
- 9.1.1 APPLICABLE DOCUMENTS 116
- 9.1.2 DESCRIPTION 116
- Notes: 119
- Chapter 10. ECL/HSSI 122
- DATA INTERFACE 122
- 10.1.2 DESCRIPTION 122
- 10.1.4.1 T 123
- TRANSPORT PROTOCOLS 123
- 10.1.5.1 S 133
- IMPLEMENTATION 133
- 10.1.6 FAULTS 134
- 11.1.1 DESCRIPTION 136
- PPLICABLE DOCUMENTS 139
- PECIFICATION SUMMARY 140
- RANSMIT SPECIFICATIONS 141
- 11.1.4.1 T 143
- 2047 PATTERN GENERATION 143
- 11.1.8 MODULATOR INTERFACE 146
- 11.1.9 POWER REQUIREMENTS 146
- Chapter 12. SMPTE-310 148
- 12.1.2 DESCRIPTION 148
- 0.0 V ± 0.5 V 150
- NTERFACE DEFAULTS 154
- Chapter 13. ASI/LVDS 157
- 13.1.2 DESCRIPTION 157
- Loopback and Loop Thru 159
- 13.1.3.1 JUMPER SELECTION 161
- 13.1.4 LOOPBACK 162
- 13.1.4.2 LOOP THROUGH 163
- SYSTEM TOPOLOGY 167
- (FAST) OPTIONS 167
- 14.2 IMPLEMENTATION 168
- Appendix A. REMOTE CONTROL 171
- OPERATION 171
- A.1.1 START CHARACTER 172
- A.1.2 DEVICE ADDRESS 172
- A.1.3 COMMAND/RESPONSE 173
- A.1.4 END CHARACTER 174
- Command: 176
- MODULATOR CONFIGURATION 177
- 3 = Center) 178
- A.2.2.1 RS-422 INTERFACE 179
- A.2.2.2 LVDS INTERFACE 179
- NTERFACE 180
- A.2.2.4 ASI/LVDS INTERFACE 181
- A.2.2.6 G.703 INTERFACE 182
- A.2.2.7 ECL/HSSI INTERFACE 182
- YSTEM CONFIGURATION COMMANDS 185
- TATUS COMMANDS/RESPONSES 186
- Modulator Output Power 187
- A.5 STORED FAULTS STATUS 188
- CONSOLIDATED STATUS 190
- A.5.3 CHANGE STATUS 194
- NTERFACE COMMANDS 196
- A.10 G.703 COMMANDS 204
- A.11 SMPTE 310M COMMANDS 206
- DISPLAY OPTION 211
- Errata A 213
- Comments: 213
- Change Specifics: 213
- Errata D 214
- Errata C 215
- Errata B 216
- Errata E 217
- Temperature Conversions 265
- Units of Weight 265
- METRIC CONVERSIONS 265
- Units of Length 265
- 480 • 333 • 2200 PHONE 266
- 480 • 333 • 2161 266
Prodotti e manuali riguardandi Apparecchiature Comtech-ef-data SDM-2020
Apparecchiature Comtech-ef-data HPOD Manuale Utente
(150 pagine)
(150 pagine)
© 2020, manymanuals.it. Tutti i diritti riservati | 0.060 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale