
RCS20 M:N Redundancy Switch Revision 15
Electrical Interfaces MN-RCS20 and CD-RCS20
5–22
59 IDR ESC Transmit 8 Kbps Output Data B ESCTXD-B Input
60 IDR ESC Receive 8 Kbps Clock Output B ESCRXC-B Output
61 IDR ESC Receive 8 Kbps Data Output B ESCRXD-B Output
62 IDR ESC Backward Alarm Out 4 Normally Open ESCBWO 4NO ---
63 IBS Transmit Octet Input B TXO-B Input
64 Synchronous Data Data Mode Out B SYNC DM-B Output
65 Synchronous Data Clear to Send B SYNC CS-B Input
66 IBS Receive Octet Output B RXO-B Output
67 Synchronous Data Request to Send B SYNC RS-B Input
68 Synchronous Data Receiver Ready B SYNC RR-B Output
5.3.2.2 J9 | MODEM 9 | BACK UP 2 68-Pin High Density Min DSUB Connector
J9 | MODEM 9 | BACK UP 2 connects to Backup Modem 2 in a 2:N configuration, or to the prime modem
9 in a 1:9 configuration. See section 5.3.2.1for pinout table.
5.3.2.3 J10 | BACK UP 1 68-Pin High Density Min DSUB Connector
J10 | BACK UP 1 always connects to backup modem 1 since there is always at least one backup modem
in a redundancy system. See section 5.3.2.1for pinout table.
5.3.2.4 J31 | RCU-20 15-pin High-Density DSUB Connector
J31 | RCU-20 connects the DDS20 to the RCU20 providing power, ground, and serial control.
1 Serial Control Clock DDS_LCLK IN
2 Relay +6 Volts VCC_RELAY IN
3 Serial Control Data 2 DDS_LDAT2 Bidirectional
4 Ground GND ---
5 Ground GND ---
6 Logic +5 Volts VCC IN
7 Relay +6 Volts VCC_RELAY IN
8 Relay +6 Volts VCC_RELAY IN
9 Ground GND ---
10 Ground GND ---
11 Relay +6 Volts VCC_RELAY IN
12 Serial Control Data 1 DDS_LDAT1 Bidirectional
13 Ground GND ---
14 Serial Control Data 3 DDS_LDAT3 Bidirectional
15 DDS20 Interrupt INT OUT
Commenti su questo manuale