Comtech-ef-data RCS20 Manuale Utente Pagina 42
- Pagina / 202
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–8
2. Press <TOG MODE> to switch through the choices above.
3. Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
4. Press <ENT> to load the information on the screen into the switch parameter table.
Key Label Function
S1
Press to move the blinking cursor to the left. Used to select the channel
connection.
S2
Press to move the blinking cursor to the left. Used to select the channel
connection.
S3
TOG
MODE
Used to toggle through the choices above. Multiple connections may be entered.
S4 NEXT Press to cycle to the next screen.
Numeric Keypad ---
Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
Press <ENT> to load the information on the screen into the switch parameter table.
4.3.1.2 MODEM ADDRESSES
This screen allows the user to program the remote addresses of each modem connected to the
redundancy system. All addresses must be in the range of 32 to 255 decimal. All entries on this screen
are in decimal. Multiple addresses may be programmed.
4.3.1.2.1 Programming steps:
1. Press or to move the blinking cursor to the channel to be programmed.
2. Use the numeric keypad to enter the address for the channel at the cursor.
3. Enter an address for each modem connected to the redundancy system at the blinking cursor.
Addresses for channels that do not have a modem connected will be ignored.
4. Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
5. Press <ENT> to load the information on the screen into the switch parameter table.
Key Label Function
S1
Press to move the blinking cursor to the left. Used to select the modem (labeled Modems
MODEM ADDRESSES USE KEYPAD
B2 B1
1 2 3 4 5 6 7 8 9 0
101 102 103 104 105 106 107 108 109 110
<--- ---> NEXT
- M:N Redundancy Switch 1
- Blank Page 4
- Table of Contents 5
- Table of Contents - ii 6
- Table of Contents - iii 7
- Table of Contents - iv 8
- FIGURES 9
- Table of Contents - vi 10
- PREFACE 11
- Preface - ii 12
- Electrical Safety 13
- Related Documents 13
- Comtech EF Data Headquarters 13
- Warranty Policy 14
- Limitations of Warranty 14
- Exclusive Remedies 14
- Chapter 1. Introduction 15
- 1.3.2.1 Universal DDS20 18
- 1.3.3.1 70/140 IFS20 22
- Chapter 2. Installation 25
- 2.2.1 Test Data Sheet 26
- 2.3 Removal and Assembly 26
- 2.4 Installation Planning 26
- 2.4.1 Rack Information 26
- 2.4.3 Electrical 28
- 2.4.3.1 Grounding 28
- 2.4.3.2 Battery 29
- 2.4.3.3 Fuses 29
- 2.5 Connecting the RCS20 29
- 2.8 Storage 30
- 3.1 Overview 31
- 3.2 RCU20 Major Assemblies 31
- 3.2.2 Front Panel 31
- Chapter 4. User Interfaces 35
- 4.2.1 Modem Control Keys 36
- 4.2.1.1 MODEM MOD CONFIG 36
- 4.2.1.2 MODEM DEMOD CONFIG 36
- 4.2.1.3 MODEM INTFC CONFIG 36
- 4.2.5 Switch Status LEDs 38
- 4.2.6 Numeric Keypad 38
- 4.2.7 Soft Keys (S1 - S4) 38
- 4.3 Front Panel Screens 41
- 4.3.1.2 MODEM ADDRESSES 42
- Key Label Function 48
- Numeric Keypad 48
- 4.3.1.19 MOD FAULT DELAY 58
- 4.3.1.20 DEMOD FAULT DELAY 59
- 4.3.1.21 DEMOD AQU DELAY 60
- 4.3.2.13 SET DATE 75
- 4.3.2.14 SET TIME 76
- 4.3.2.22 CnC SWITCHING 82
- 4.3.3.3 EVENTS 89
- 4.3.3.4 NEXT EVENTS SCREEN 90
- 4.3.4 TEST Menu Tree 93
- 4.3.4.1 SWITCH SYSTEM TESTS 93
- 4.3.4.4 LAMP TEST 96
- 4.3.4.6 REMOTE PORT TEST 97
- 4.4 Remote Interface 97
- 4.5 Terminal Port Control 98
- 4.5.1 Terminal Interface 98
- 5.1 Overview 101
- 5.2.2 Chassis Ground 102
- 5.2.3 Expansion Slots 103
- 5.2.3.2.1 J1 106
- 5.2.3.2.2 J2 106
- 5.2.3.2.3 J3 107
- 5.2.3.2.5 J2 108
- 5.2.3.2.6 J3 108
- 5.2.3.2.4 J1 108
- Female Connectors 120
- G.703B DDO-B SYNC ST-B 121
- 5.4.2.4 J21 124
- BLANK PAGE 134
- Chapter 6. Maintenance and 135
- Troubleshooting 135
- 6.3 Active Major Alarms 136
- 6.4 Active Minor Alarms 137
- 7.1 General Specifications 139
- 7.2 IFS20 (70/140 MHz) 139
- 7.3 IFS20 (L-Band) 140
- 7.4 Terrestrial Interfaces 140
- 7.5 Options 141
- 7.6 Power and Environmental 141
- 7.8 Complementary Products 142
- A.1.1 Protocol Structure 143
- A.1.2 Protocol Wrapper 144
- A.1.5 Collision Avoidance 148
- A.1.8 RLLP Summary 152
- Configuration 168
- Appendix B. System Cabling 179
- B.2 RCS20 Interconnects 180
- Setup and Configuration 199
- 480 • 333 • 2200 PHONE 202
- • 333 • 2161 FAX 202
Prodotti e manuali riguardandi Apparecchiature Comtech-ef-data RCS20
Apparecchiature Comtech-ef-data C5 Manuale Utente
(332 pagine)
(332 pagine)
© 2020, manymanuals.it. Tutti i diritti riservati | 0.074 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale